If you want to buy a worm gear reducer, it is necessary to understand it. The basic structure of the Italy gear reducer is mainly composed of transmission parts, worm gear, shaft, bearing, box and its accessories.

It can also be divided into three basic parts: box, worm gear, bearing and shaft. The box is the base of all the parts in the worm gear reducer. It is an important accessory to support the fixed shaft parts, to ensure the correct relative position of the drive parts and to support the load on the reducer. The main function of the worm wheel is to transfer the motion and power between the two intersecting shafts. The main function of the bearing and the shaft is power transmission, operation and efficiency improvement.

Worm gear reducer parts:

The hood / aerator is mainly used to expel the gas in the turbo worm gear box;

The end cover, divided into big cap and small cap cover for the axial position of fixed shaft components and under axial load, closed at both ends of bearing hole for bearing cover;

The main use of the oil seal is to prevent the leakage of lubricating oil from the inside of the case and improve the use time of the lubricating oil;

Oil drain plug, mainly used to change the oil discharge of waste oil and cleaning agent;

The oil mark / oil mark is mainly used to observe whether the oil in the turbo worm gear box is up to the standard;

Italy VARVEL reducer, /VARVEL transmission, /VARVEL motor, /varvel gear reducer motor, /varvel reducer